[Avail] SHIMANO Microcast Spool CC5017/CC5032 for 05 CALCUTTA 50/51, CALCUTTA XT 50/51 *discontinued
[Avail] SHIMANO Microcast Spool CC5017/CC5032 for 05 CALCUTTA 50/51, CALCUTTA XT 50/51 *discontinued
Our Selling Price: US$57.22 - US$79.24 [Regular Price: US$81.73 - US$113.19]
Prices vary according to options.
Retail Price: US$111.96
Not available
|Regarding the stock of AVAIL product
It takes us two to three days to get ready to send Avail products
because we order them from the Avail factory.
Sometimes they might be out of stock at the timing of your order.
In the case of a stockout, we refund your purchase price immediately.
|Type and description
Avail Microcast Spool CC5017
(The spool rim level is 1.7mm)
Avail Microcast Spool CC5032
(The spool rim level is 3.2mm)
This model is for CALCUTTA 50XT, 51XT, and '05 CALCUTTA 50, 51.
Either genuine centrifugal brake or special magnetic brake can be equipped.
|Spool colors
・NAVY
・RED
・GOLD
・GUNMETAL
|Braking system options
With No brake
※When you just remove SVS from your genuine spool and use it, please choose here.
At the most reasonable price, you can try the performance of lightweight spool.
With a magnetic brake
(Avail Microcast Brake CC5017)
(Avail Microcast Brake CC5032)
※ Although the attachment would be difficult, fine tuning of the magnetic brake is possible even with SHIMANO reel.
|Spec
|Material
Spool : extra super duralumin
Shaft : stainless-steel
|Compatibility
CALCUTTA 50XT/51XT
'05 CALCUTTA 50/51
|Weight
Microcast Spool CC5017 : 9.6g
(The weight ratio against genuine product approximately 57%)
Microcast Spool CC5032 : 9.7g
(The weight ratio against genuine product approximately 58%)
SHIMANO genuine spool (CALCUTTA 51XT) : 16.8g
|Line capacity
CC5017 10Lb-40m:8Lb-50m:6Lb-60m
CC5032 10Lb-55m:8Lb-70m:6Lb-85m
※The numerical value mentioned above is the result of measuring by winding nylon line up to the edge of spool rim.
|Instruction
|How to replace SVS brake
Take SVS off the genuine spool.
The brake unit is press-fitted.
Loosen the unit by liftiing little by little.
Then pull straight out from spool.
Please be careful not to damage the brake and scratch spool rim.
Press brake unit into Microcast Spool tightly.
Since the total weight of spool gets lighter, you will use less number of brake block.
※As for removing and also attaching, please do so on your own responsibility.
|How to attach magnitic brake
Avail Microcast Brake CC5017(Additional option)
Avail Microcast Brake CC5032(Additional option)
Brake unit is required separately.
Attach the brake to handle side unit.
Place the magnetic brake on the bearing in the unit as pictured above.
From another angle
Press thoroughly up to the bottom.
Put the spool back and attach it into main frame to finish up.
※How to adjust the magnetic brake
There are 4 magnets in the brake.
Place those magnetic poles next to each other alternately.
The more numbers of magnet, the stronger the brake works