[Avail] ABU Microcast Spool for Morrum SX 1600C/1601C ULTRAMAG [SXUM1618R]

ABU Morrum SX 1600C/1601C for ULTRAMAG

Model Name

MS_SXUM1618R


Product Introduction

This microcast spool is exclusively for ABU Morrum SX 1600C/1601C ULTRAMAG (magnet brake type).
The spool weight and line capacity have been reduced to lighten the entire spool significantly.
This improves the spool response, enables the casting of light lures such as 5 g - 2 g, and increases the casting distance of lures of the same weight.


Color



Gunmetal


Specs

Basic Specifications

- Spool diameter/width
35 mm / 23 mm

- Spool body material
Super duralumin (colored by anodizing)

- Spool shaft material
Super duralumin (anodized-white)

- Brake disc material
Super duralumin (anodized-black)

- Drive pin material
Stainless steel

- Installed bearing
MS-SXUM1618R: Outer diameter 10 mm x Inner diameter 4 mm x Thickness x 4 mm
Genuine: Outer diameter 10 mm x Inner diameter 4 mm x Thickness 4 mm

- Compatible reels
Morrum SX 1600C, 1601C ULTRAMAG
Morrum SX 1600C, 1601C ULTRAMAG FORELL
Morrum SX 1600C, 1601C ULTRAMAG S2
Morrum SX 1600C, 1601C ULTRAMAG S2-V

*Morrum SX Hi-Speed/MAG/IVCB/ZX series are not compatible

*We do not sell drive pins separately. We cannot respond to inquiries about them.
Therefore, please avoid damaging or losing them when replacing the bearings.

Weight

Spool	Weight	Weight ratio
MS_SXUM1618R	7.2 g	49 %
Genuine spool	14.5 g	-

*The weight may vary slightly depending on the production lot.


Line Capacity

PE	#0.4	#0.6	#0.8
MS_SXUM1618R	100 m	80 m	60 m
Nylon	#1 (4lb) Diameter: 0.165 mm	#1.5 (6lb) Diameter: 0.205 mm	#2 (8lb) Diameter: 0.235 mm
MS_SXUM1618R	60 m	40 m	30 m

- Measured using SHIMANO "Pitbull 4 (PE)".
- Measured using Yamatoyo Tegusu Co., Ltd. "Versatile Design (Nylon)."
*The above values are measured by winding the line up to the spool rim C surface.


Laser Marking



The spool side has the "model name" and "line capacity" marked by laser for identification purposes.


Brake Disc



On the palming side of MS-SXUM1618R, a brake disc is installed.


Caution

This product is a light tackle spool that sacrifices some strength to improve the casting distance of light lures.
Especially when using nylon lines, there is a risk of spool damage due to the swelling and contraction caused by the water absorption characteristic of nylon.
Please be careful not to leave the line wound, apply too much tension when winding the line, press the spool and jerk it when removing a snag, or pull and cut it, as these may also cause damage.


Installation Method



The installation method of MS-SXUM1618R is available on Avail's official YouTube, so please refer to it.