Bearing method of replacing the standard Shimano bait reel




We will continue to the exchange of the spool bearing.
Replace the bearings are located in the interior of the side cover plate and the mechanical brake knob.





Of you to prepare only precision flat-blade screwdriver to be used when removing the replacement bearing two and the bearing stopper ring.



Before work, it will be promoted to the side cover plate and the spool smoothly and should be removed from the reel body.


Bearing How to replace the side cover plate portion



First, remove the bearing stopper ring of the arrow (pentagon of the wire ring).




Precision a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.




At this time, you can prevent the loss of parts and to work while pressing lightly the bearing stopper ring in the opposite side of the finger.
Even if you if you lose unexpectedly spare bearing stopper ring We are also ready.




After removing the bearing stopper ring and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.




Install the replacement bearings.
Mounting method is only'll simply put a hand to the site that contained the bearing.




Then attach the bearing stopper ring.
Until it snaps into the groove and push the bearing stopper ring finger.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.




It is successfully completed work if each part is attached as shown in the photograph.


Bearing method of replacing the mechanical brake knob part




Replace the bearings in the internal mechanical brake knob of the arrow part.




First, remove the mechanical brake knob.




Bearing to replace the removal of the mechanical brake knob is visible.




First, remove the bearing stopper ring of the arrow (pentagon of the wire ring).
Precision a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.




At this time, you can prevent the loss of parts and to work while pressing lightly the bearing stopper ring in the opposite side of the finger.
Even if you if you lose unexpectedly spare bearing stopper ring We are also ready.




After removing the bearing stopper ring and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.


※ attention


to the part of the Shimano reel (released after 2012 model year), but there is a model that contains the removed further bearing on the inside of the bearing, bearing of the arrow part is the site has nothing to do with this time of bearing replacement please do not touched since .




Install the replacement bearings.
Mounting method is only'll simply put a hand to the site that contained the bearing.




Then attach the bearing stopper ring.
Until it snaps into the groove and push the bearing stopper ring finger.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.




It is successfully completed work if each part is attached as shown in the photograph.




Finally fitted with a mechanical brake knob, and then install the spool and the side cover to the main body.
Check the rotation of the spool by turning the handle, is complete all of the work if the work without problems.