Bearing exchange method of Moramu ZX



First, loosen the screw portion of the handle side of the arrow.






Then, it can be decomposed into three such as the reel body spool.






Of you to prepare the replacement bearing two and disposable chopsticks, it is a spool bearing remover.




Bearing exchange of the side cover part





First, replace the bearings in the arrow part.






The structure of the site, bearing has been fixed by being covered with plastic parts.
So, you must first remove the plastic parts.
On removing, Ategai to plastic parts as shown in the photograph using chopsticks, please remove lift it up in the principle of leverage.

In this case, please be sure to use the chopsticks because there is a possibility of damage to the other parts in the work and the use of such as a flat-blade screwdriver.






Once safely removable, you can retrieve the plastic parts and the spring.






After removing the bearing stopper ring and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.






Replace the genuine bearing on your choice of bearings.








Attach the bearing to the reel body.






Install the spring as shown in the photograph.






The plastic parts and then fixed by pushing with your finger.






This is the attachment end of the bearing.




Bearing exchange of the spool shaft portion



Bearing of the spool shaft section also allows you to exchange With the spool bearing remover.






The removal of the shaft pin spool bearing remover you used.




AIR HD, the case of ZR bearing



When broken down here can remove the bearing from the spool, it allows bearing exchange.





Attach the bearing of hope to the spool shaft.






After the exchange is completed work be attached again using a spool bearing remover the shaft pin.






Finally assembled each of the parts, is the work completed if the operation without any problems.




In the case of AIR BFS bearing




When broken down here can remove the bearing from the spool, it allows bearing exchange.






When installing the AIR BFS bearing, install a washer that came before installing the bearing.
First of all, from the left, please be incorporated into the order of the washer of 0.2mm · 0.2mm · 0.8mm.






Install the AIR BFS bearing.






After the exchange is completed work be attached again using a spool bearing remover the shaft pin.






Finally assembled each of the parts, is the work completed if the operation without any problems.