PX68 for finesse bearing how to replace the spool



Bearing of the spool shaft section also allows you to exchange With the spool bearing remover.






The removal of the shaft pin spool bearing remover you used.
※ spool bearing remover more information on how to use, please refer to the product page.




After removing the shaft pin, and remove the bearing from the housing.
Bearing stopper ring is fixed at, but precisely a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.






In this case, bearing stopper ring can prevent the loss of parts and to work while pressing lightly with the opposite finger. Even if you if you lose unexpectedly spare bearing stopper ring We are also ready.






Bearing stopper ring after removal of the and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.




Mounting method in the case of AIR HD · AIR · ZR bearings



When broken down here can remove the bearing from the spool and housing, it enables the bearing exchange.






After installing a replacement bearing in the housing and snap it into the inside of the groove and push the bearing stopper ring finger.

At this time, the open surface of the bearing is to face the bearing stopper ring side please do the installation with care.

Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.






Attach the bearing to the housing each spool shaft.

After installation, the shield surface of the bearing has can be installed without any problem if seen.




※ Caution


When you do embedded in a state that does not attach the housing to the bearing, cause of failure not spool to neatly operation after assembly.
The occasion of the built-in , please make sure that you always housing is attached to the bearing .






After bearing mounting, again the shaft pin spool bearing remover is the work completion be attached using.




Mounting method in the case of AIR BFS bearing



When broken down here can remove the bearing from the spool and housing, it enables the bearing exchange.
Washer such installation of the AIR BFS bearing is separately supplied with the bearing body also do the installation.






After installing a replacement bearing in the housing and snap it into the inside of the groove and push the bearing stopper ring finger.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.






Attach the silver washer and black plastic ring to the spool shaft before mounting the bearing to the spool. The order in which install, please note that the silver washers will be the first.






Attach the bearing to the housing each spool shaft.




※ Caution


When you do embedded in a state that does not attach the housing to the bearing, cause of failure not spool to neatly operation after assembly.
The occasion of the built-in , please make sure that you always housing is attached to the bearing .






After bearing mounting, again the shaft pin spool bearing remover is the work completion be attached using.