Bearing exchange of Alfaz AIR

Bearing exchange of side cover plate side



Loosen the brake dial screw on the brake dial portion of the side cover and remove the side cover.






Then, it can be decomposed into the reel body-side cover spool.






Of you to prepare only precision flat-blade screwdriver to be used when removing the replacement bearing two and the bearing stopper ring.




Side cover plate portion bearing the exchange of the





first, and remove the bearing stopper ring of the arrow (pentagon of the wire ring).






Precision a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.






In this case, bearing stopper ring can prevent the loss of parts and to work while pressing lightly with the opposite finger. Even if you if you lose unexpectedly spare bearing stopper ring We are also ready.






Bearing stopper ring after removal of the and take out the genuine bearing.
At this time, the handle knob cap remover is easy to recommend because it can be taken out by hooking the bearing With such.



By removing the bearing stopper ring enables genuine bearing is taken out exchange.






After installing the replacement bearings and snap it into the inside of the groove and push the bearing stopper ring finger.
Please try to be working again push the bearing to the back if the bearing stopper ring does not fit well.




It is successfully completed work if each part is attached as shown in the photograph.




Bearing exchange of the spool shaft side



Bearing of the spool shaft section also allows you to exchange With the spool bearing remover.






The removal of the shaft pin spool bearing remover you used.
※ spool bearing remover more information on how to use, please refer to the product page.




If missing the shaft pin can be removed genuine bearings, it enables exchange.






After the exchange is again a shaft pin spool bearing remover is the work completion be attached using.






Assemble the reel, please perform the operation check whether there is a problem.