Shimano 08 Metaniumu MgDC / MgDC7 DC unit inside of the bearing How to Replace

---

Open the side cover, and remove the inner lid that DC unit is attached.

Then, it can decompose the reel body spool · DC unit.

Remove the three screws on the spool surface of the removed inner lid.

After removing the screws, remove the metal plate.

Next, remove the wire ring that is attached between the inner lid and the DC unit.
How to remove the negative precision screwdriver so as to scoop put in between the middle and the wire cover, the working position can be done smoothly performed from the break of the wire ring.

Now you can remove the wire ring.

You can separate the inner lid and the DC unit and remove the wire ring.
When the decomposition so far enables the exchange of bearings.

Bearing bearing stopper ring can be easily removed by using the such as flathead screwdriver because it is only been fixed in.
By removing the bearing stopper ring enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.

If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.

Attached to the inner lid of the bearing, bearing stopper ringIn and secure.

The middle lid and the DC unit again and secure it with the wire ring.

Install the metal plate and three screws.
In this case, the metal plate has orientation.
Please attach, taking care so that the protruding portion of the metal plate is shown in the photograph.

Return the DC unit to the body. At this time, the red circle part of the photos please go to the mounting so as to overlap.

Finally, is the work completed and if there are no problems, check the operation by turning the handle like.