Baitcasting Reel
Shimano 11 bearing method of replacing the DC unit section of Calcutta Conquest 50DC series
First, remove the side cover plate.
Remove the three screws that secure the reel unit and the DC unit in a photograph arrow portion.
Because it is shorter than the other bis only bis photo top right corner when mounting Please note.
※ The removal of the three screws hex driver of 2.0mm is required.
There is and turned over the removed DC unit three-bis (Phillips-head screws) so, they are also removed.
It can be decomposed into four parts as shown in the photograph the DC unit and remove all of the screws.
When the decomposition so far enables the exchange of bearings.
Bearing bearing stopper ring can be easily removed by using the such as flathead screwdriver because it is only been fixed in.
By removing the bearing stopper ring enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.
If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.
And when after the exchange was decomposition is the work completed if it is possible to assemble in the reverse order.
Shimano 11 bearing how to replace the spool shaft portion of Calcutta Conquest 50DC series
The Calcutta Conquest 50DC series of the spool has a bearing on the site of the arrow, it can be replaced by removing the shaft pin.
The removal of the shaft pin spool bearing remover you used.
※ spool bearing remover more information on how to use the product page please visit.
If missing the shaft pin can be removed genuine bearings, it enables exchange.
The size of the spool bearing is 1150ZZ size (inner diameter 5 mm × OD 11 mm × thickness 4 mm).
Please use your favorite type of bearing.
⇒ 1150AIR HD Or 1150AIR Or 1150AIR BFS Or 1150ZR Or 1150ZHi
after the exchange is again a shaft pin spool bearing remover is the work completion be attached using.