Bearing exchange method of Calcutta Conquest 50



First, Unscrew and remove the internal cap of the side cover side in a counterclockwise direction.
Then reel body spool it can be divided into internal cap, work smoothly is advanced.





Of you to prepare only precision flat-blade screwdriver to be used when removing the replacement bearing two and the bearing stopper ring.




Bearing exchange method of a centrifugal brake side



First of all, bearing stopper ring (pentagon of the wire ring) and remove the.
Precision a flathead screwdriver addressed as shown in the photo to a piece of the bearing stopper ring, you can remove and scoop up from the bottom while pressing a little to the inside of the bearing stopper ring.




In this case, bearing stopper ring can prevent the loss of parts and to work while pressing lightly with the opposite finger.






Bearing stopper ring by removing the enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.

If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.






Install the replacement bearings. Mounting method is only'll simply put a hand to the site that contained the bearing.
Then, bearing stopper ring until it snaps into the groove and push the a finger.
Bearing stopper ring Please try to be working again push the bearing to the back if you do not snap well.






It is successfully completed work if each part is attached as shown in the photograph.




Bearing method of replacing the mechanical brake knob part



HP will replace genuine bearing on the mechanical brake in the knob.






Be removed by turning the mechanical brake knob body in a counter-clockwise, you can check the are incorporated bearing.

Remove the bearing stopper ring with a minus screwdriver in the same manner as the time of bearing replacement of the internal cap.
At this time, you can prevent the loss of parts and to work while pressing lightly the bearing stopper ring in the opposite side of the finger.


· AIR HD · In the case of AIR · ZZ bearings



by removing the bearing stopper ring enables the exchange to retrieve the genuine bearing.
If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.






And when after the exchange was decomposition is the work completed if it is possible to assemble in the reverse order.




· AIR BFS case of bearing



exchange genuine bearing is taken out by removing the bearing stopper ring will be possible.
If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.

It should be noted that, when installing the AIR BFS bearings , please use the triangle type of bearing stopper that comes with the bearing kit .






And when after installation was decomposition it is the work completed if it is possible to assemble in the reverse order.




Bearing exchange method of the spool shaft portion



The spool shaft portion of Calcutta Conquest 50 series there is a bearing, can be replaced by removing the shaft pin.






The removal of the shaft pin spool bearing remover you used.
※ spool bearing remover more information on how to use, please refer to the product page.






If missing the shaft pin can be removed genuine bearings, it enables exchange.

The size of the spool bearing is 1150ZZ size (ID 5 mm × OD 11 mm × thickness 4 mm).
Please use your favorite type of bearing.
⇒ 1150AIR HD / 1150AIR / 1150AIR BFS / 1150ZR / 1150ZHi






after the exchange is the work completed by attaching again using a spool bearing remover the shaft pin.




※ Note



Calcutta Conquest 50S series of spool, it can not be exchange of bearings .
Other Shimano genuine spool, micro-cast spool of Avail also 50S for the series can not replace the bearings.

Since the spool bearing remover can not be used to 50S series of the spool, please note.