Bearing method of replacing the DC unit Shimano 15 Metaniumu DC



First, turn the brake dial until you see the character of OPEN.






Then move the lever of the arrow portion toward the OPEN.






This can be taken out of the side cover, it can be decomposed into the reel body spool side cover.






So, remove the DC unit from the side cover.
First, remove the three screws of the arrow.




Removing the three screws can be disconnected DC unit, but this is the reel have small parts are attached to the position of the photograph of the arrow.






Although's a small spring and sounding pin, please take care because these parts are very easy to eliminate.






And promote the decomposition taking care ahead of the parts will be shown in the photograph.
You can replace the bearings and decomposition so far.




Bearing bearing stopper ring can be easily removed by using the such as flathead screwdriver because it is only been fixed in.
By removing the bearing stopper ring enables genuine bearing is taken out exchange.
It should be noted, bearing stopper ring Please use, for example, when the preliminary even that has been damaged or lost because the offers.

If the bearing is difficult to take out the handle knob cap remover you can easily exchange work be taken out as hooking using.


In, and secure again to the side cover of the DC unit.





First, assemble the three parts of the decomposed DC unit earlier.
Then, I attach the DC unit to the side cover plate, please check whether the small spring and a sounding pin has been properly attached to the red circle of position at this time side cover plate side. And the tip of the sounding pin is please do the assembly to fit into the recesses in the red circle the site of the DC unit side.






In three screws to secure the DC unit.
Finally, when you install the side cover to the reel body, whether there is a problem with the rotation of the one-spool lever a click sound is depending on whether the lever operation to run smoothly please confirm.
Please check the position and orientation of each part is decomposed again if there is a sense of incongruity.

This work is complete if there is no problem.