16 Metaniumu MGL bearing How to Replace


16メタニウムMGLのベアリング交換方法

16 Metaniumu MGL is different from the 13 Metaniumu, replace the there since it has a bearing is attached to the spool.
※ side cover plate side, this is the same as the 13 Metaniumu.


Bearing exchange method of the spool shaft portion


16メタニウムMGLベアリング交換

In order to replace the spool bearings, you must remove the shaft pin and E-ring.




16メタニウムMGLベアリング交換

First of all, we will remove the spool shaft pin. Shaft pin is different from the thickness of the left and right, but it does not matter is pulled out from either.




16メタニウムMGLベアリング交換

The spool shaft pin will disconnect with the spool bearing remover.

※ If you do not have a spool bearing remover, we also sales and rental.
→ For more information about the spool bearing remover, please click here.




16メタニウムMGLベアリング交換

Then we will remove the E-ring.




16メタニウムMGLベアリング交換

First, create a simple wall by using a wide tape width as E ring is not Ika fly (such as transparent packing tape) while working.




16メタニウムMGLベアリング交換

Use two toothpicks to work from here. Hook the tip of the toothpick at both ends of the E-ring and remove the E-ring is pushed to two simultaneous.

※ because that would hurt if you using a metal tool such as pliers the spool shaft and the spool body you use, please refrain.


16メタニウムMGLベアリング交換

The above-mentioned parts will be taken out by removing the E-ring. Please note especially the loss of the washer in the spring both ends. Here replace the bearings.




16メタニウムMGLベアリング交換

In it will return to the original. Washer ⇒ Attach to spring ⇒ spool shaft in the order of the washer ⇒ bearing. Then, in the groove on the position of the photograph of the arrow Install the E-ring.




16メタニウムMGLベアリング交換

After initially pushed lightly E ring with your fingers and further push the E ring on the opposite side of the part with the tip of the toothpick.




16メタニウムMGLベアリング交換

Both ends of the E ring is okay if me to the position of the photograph.




16メタニウムMGLベアリング交換

Finally, it returns the spool shaft pin on the basis of using the spool bearing remover. This work completed if it can be confirmed that the both ends of the shaft pin is out at a uniform length.